Resources:
User Manual
Cut Sheet
CAD Drawing .dwg
CAD Drawing .pdf
CAD Drawing Ground .dwg
CAD Drawing Ground .pdf
Electrical Specifications :
Input: 115 VAC +/- 10%, 60Hz
Output: 24 VAC, 2.0A
Over-Load backup fuse: SLow-blow, self-healing fuse: 2.5 Amps
Battery Backup: One CR2032 battery for internal clock. Battery life is approximately 10 years of
continuous operation without power.
Load Capacity per terminal: 0.6 Amps max continuous load (2 solenoid/ valves/ relays per terminal max)
Electrical Surge Protection: Input: Transient Voltage Suppressor (TVS) Common Wires, Signal Ground:
5000 Amp Gas Discharge Tube to Earth Ground Earth Ground Terminal: Up to #6 copper wire for diverting electrical surges to a ground rod
Physical Specifications:
WIdth: 12 1/4" (31.0 cm)
Height: 10" (26.0 cm)
Depth: 5 7/8" (5.0 cm)
Models:
ACC-SYS-3500, 110VACACC-SYS-3500I, 220VAC
| Home > Products > Controllers > CS3500
CS3500
Water on Demand® Irrigation Controller
Each zone can be set to one of three modes of operation: as a reference zone with its own sensor, as a dependent zone that racks a reference zone, or as a timed zone. The CS3500 easily accommodates both drip and spray zones. No matter who complicated your irrigation system this controller will keep up.
The CS3500 has the ability to set, maintain and monitor any desired moisture level. Once moisture levels are set, the controller self corrects for changes in soil conditions. During the hottest part of the year, the controller might water every day. Then when the temperature cools, or rainfall occurs, the controller prevents zones from watering until the moisture level in the ground falls below the moisture level you have set. With sensors determining when to water the controller has more time to water those zones in need of water and delaying those that do not. Multiple zones can be watered simultaneously and Acclima’s flow control optimizes the water use.
Features:
- Optional sensor-mode operation saves water and adjusts to weather patterns
- Sophisticated central control capabilities using Acclima Irrigation Manager™ Software
- Advanced communications capabilities through serial cable, dial-in modem, Acclima Access™ voice/cell phone, or radio communications
- 2-wire system flexibility and ease
- Water on Demand efficiently irrigates only when the soil needs moisture and will only apply the water needed
- Flow meter support monitors for broken pipes
- Multi-zone watering may be configured to prevent loss of water pressure
- Cycle + Soak feature prevents runoff by putting down the water in short bursts
- Programmable valve delay allows slow-closing valves time to turn off completely
- Water restriction setup for each zone if needed
- Valve test mode rapidly checks the valve current of all zones
- Walk-around rest mode operates each zone for a programmable amount of time
- Flexible, programmable manual programs
- Pause mode suspends controller operation
- Sophisticated restriction capabilities allowing for complex water schedules
- one status reporting lists history of errors that may have occurred on the system
- Operation status report
- Adaptable to the TRC Commander radio through a separate adapter
- Clock settings can be maintained for up to 10 years without power
Operating Specifications:
- Six programmable pause events
- Zone run-times can be set from 0 to 18 hours in 1-minute increments
- Supports up to 30 soil moisture sensors with sensor sharing
- Soil moisture sensor thresholds set from 1% to 99% water content per volume
- Multi-zone watering up to 4 zones
- Non-volatile program memory
- Durable, weather resistant cabinet
- Large graphic display with intuitive prompting simplifies programming
Wiring Guide:
Maximum Distance from Controller in feet:
|




